Villager V6-201 3.3L SOHC VIN T SFI (1999)
Torque Converter: Service and Repair
Cleaning and Inspection
1. If the torque converter is not going to be replaced, flush the torque converter.
2. If the torque converter is being replaced, partially fill the converter with Motorcraft MERCON(R) Multi-Purpose (ATF) Transmission Fluid
XT-2-QDX or equivalent meeting Ford specification MERCON(R) and hand agitate. Drain the converter and then refill for installation.
MERCON(R) automatic Transmission Fluid is being replaced by MERCON(R) V as a service fluid, as per TSB 06-14-4.
3. Flush all transaxle fluid coolers and tubes.
4. All cooler bypass valves (CBV), if equipped, must be cleaned.
5. Check the fluid cooler flow. Refer to Preliminary Inspection. If the transaxle cooling system fails the test, install a new fluid cooler, cooler bypass
valve, and/or the cooler lines.