Villager V6-201 3.3L SOHC VIN T SFI (1999)
Pulse Signal Generator: Service and Repair
Vehicle Speed Sensor (VSS)
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Remove the vehicle speed sensor (VSS).
1
Disconnect the electrical connector.
2
Remove the bolt.
3
Remove the VSS.
Installation
1. Install the VSS.
1
Install the VSS.
2
Install the bolt.
3
Connect the electrical connector.
2. Lower the vehicle.
3. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be 16 km (10 miles) or more to relearn the strategy.
Connect the battery ground cable.
