Cooper (R50) L4-1.6L (W10) (2002)
^
Remove the protective paper from one side of a second strip of sealing material and lay it on top of the first strip of protective paper so that the
wires are sandwiched in between.
^
Before removing the remaining pieces of protective paper from the sealing strips, squeeze the sealing material into the harness.
^
Repeat the operation on the other two groups of wires, remove any remaining protective paper and then bring all three bunches together.
Mould the sealing material into a single cylinder around the harness.
^
Repeat the sealing operation on the second BC1 harness.
5.
Installing the new BC1 and soft cover