Cooper (R50) L4-1.6L (W10) (2002)
/l4-1.6l_(w10)/Page-2296001.png)
Body Emblem: Service and Repair
Removing and Installing/Replacing Rear MINI Badge
51 14 012 Removing And Installing/replacing Rear MINI Badge
Special tools required:
-
00 9 322
Important: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be
observed without fail.
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on rear lid and press down firmly.
* Liner is the protective film on a new badge.
