Cooper (R50) L4-1.6L (W10) (2002)
Front Cross-Member: Service and Repair
Replacing Front Axle Support
Special Tools Required:
^
32 1 190
^
32 3 090
Remove road wheels.
Remove bumper.
Remove bumper carrier.
Remove crush tube.
Use KDS to check wheel alignment.
Remove nuts (1) securing supply tank to bulkhead.
PAS reservoir to bracket
M6 Nut ................................................................................................................................................................................................................ 8 Nm
Remove nut (2) from bracket clamp and remove clamp from tank.
PAS reservoir to bracket
M6 Nut ................................................................................................................................................................................................ 5.5 Nm ± 1 Nm
Remove nuts and disconnect steering tie rod ends using special tool 32 3 090 (1).
Outer ball joint to knuckle
M10 x 1.25 x 12 Locknut .................................................................................................................................................................................. 52 Nm
Note: Use only once.