Cooper (R50) L4-1.6L (W10) (2002)
/l4-1.6l_(w10)/Page-1379002.png)
12.
On the next screen select the right arrow.
13.
Enter full VIN Number correct? Select YES.
14.
Enter program control unit part number enter: 7547052 Number correct? Select YES, then scroll down till the end, and to the left. At this point
basic and programmed control unit part numbers are stored for programming.
15.
Select: Program basic control module, then the right arrow.
16.
Follow instructions for entering the last seven characters of the VIN. Select YES.
17.
Switch on ignition, then right arrow twice.
18.
The next screen displays: The control module can be programmed X time, then the right arrow.
19.
Follow the command for mileage entry Entry correct?. Select: YES.
20.
DME EMS2000 Start automatic programming Select: YES.
21.
After successful programming, message is displayed: Programming completed.
22.
Important: at this point turn ignition off and perform battery reset (disconnect battery cable) for 30 seconds. After that, reconnect battery.
23.
Recode EMS2000 control module. Select 3 Coding ZCS/FA.
24.
Select R50/R53, then the right arrow.
25.
Select 1 Recoding, then the right arrow.
26.
Select 95 MOTRONIC, then the right arrow.
27.
Selection correct? Select YES.
28.
Motronic start automatic coding? Select YES.
29.
After coding is completed, turn ignition off for 10 seconds and then start the engine.
Important:
The EMS2K part numbers after programming with CD 38.0, or higher should be as follows:
R50 Cooper CVT: Programmed number 7547052, Basic number 7527610.
