Cooper (R50) L4-1.6L (W10) (2002)
Transmission Position Switch/Sensor: Service and Repair
Replacing Transmission Switch
Note:
^
After completing work, top up transmission fluid.
Caution:
^
Use only the approved transmission fluid in this automatic transmission.
^
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Drain oil only when the transmission has cooled.
Disconnect connector from inhibitor switch.
Remove inhibitor switch from gearbox.
1) Electrical connector
2) Inhibitor switch
3) Oil pan
4) Sealing ring on inhibitor switch
Inhibitor switch to gearbox .......................................................................................................................................................................................... 12 Nm
Install hint:
Fit new sealing to inhibitor switch and lubricate.