mini Workshop Repair Guides

Mini Workshop Service and Repair Manuals

Customer Interest: > < Compressor Clutch Relay|Locations|Page 325
Page 1
background image

Control Module HVAC: All Technical Service Bulletins
A/C - IHKA Intermittently Won't Switch ON

SI M64 03 06
Heating and Air Conditioning Systems

October 2006
Technical Service

This Service Information bulletin supersedes S.M. M64 202 04 dated July 2004.

SUBJECT
IHKA Intermittently Doesn't Switch On

MODEL
R50, R53

SITUATION
Intermittently the IHKA does not switch on until the ignition is cycled.

CAUSE
Poor ground

PROCEDURE

1.

Identify the ground wire (pin 26.5 BR/SW) from IHKA control module connector X610.

2.

This wire is routed through 2 separate splice points.

3.

Route a dedicated ground wire to ground point X13230 located near the drivers door-opening sill.

4.

Retest the system for proper operation.

No additional IHKA control modules are needed for analysis. Do not replace any parts.

WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty

Defect Code

Refer to KSD

Labor Operation:

Refer to KSD

Labor Allowance:

Refer to KSD

Customer Interest: > < Compressor Clutch Relay|Locations|Page 325