Cooper (R50) L4-1.6L (W10) (2002)
9.
Remove inlet pressure tube (2).
Note on installation:
M6x55 bolts tightening torque: 10 Nm
10.
Carefully remove oil pump (1) out
of the housing.
Note: you need to slightly pull transmission down (using a suitable prying bar) in order to safety clear a chassis member when removing pump out of the
housing.
11.
Remove and discard two o-rings
(1). Install new o-rings (provided)
when reassembling.
12.
Discard plate spring (2).
13.
Make clear marks on both M35X1.5 nut and primary shaft to identify their original position (both markings identified by an
arrow).