Cooper (R56) L4-1.6L (N12) (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
34 52 516 Removing and Installing/Replacing DSC Control Unit
Version I
34 52 516 Removing and installing / replacing DSC control unit
Necessary preliminary tasks:
^
Remove hydraulic unit. See: 34 51 527 DSC Hydraulic Unit
Release screws (1) and carefully remove control unit (2).
Necessary preliminary tasks:
Tighten control unit on hydraulic unit
1AZ Control unit on hydraulic unit ........................................................................................................................................................................... 5 Nm
Observe following notes on installation.
Important:
Do not use force to fit the control unit.
The two pins (2) must not be bent under any circumstances!
Installation:
Carefully insert control unit (1) in direction of arrow, paying attention to the two pins (2).