Cooper (R56) L4-1.6L (N12) (2008)
Rocker Arm Assembly: Service and Repair
11 37 010 Removing and Installing/Replacing Intermediate Lever (N12)-N12
11 37 010 Removing and installing/replacing intermediate lever (N12)
Special tools required:
^
11 4 480
^
11 5 571
^
11 9 571
^
11 9 572
^
11 9 573
Warning:
Danger of injury!
A special tool is essential for opening the return spring on the intermediate lever.
Necessary preliminary tasks:
^
Remove cylinder head cover.
Important:
Release screw with special tool only.
Position special tool 11 9 571 on bearing block of balancing shaft so that it rests on intermediate shaft (see arrow).
If necessary, set eccentric shaft (1) to minimum lift (2).
Clamp return spring with knurled screw (1).