Cooper (R56) L4-1.6L (N12) (2008)
Variable Valve Timing Actuator: Service and Repair
11 37 005 Removing and Installing/Replacing Eccentric Shaft
11 37 005 Removing and installing/replacing eccentric shaft (N12)
Special tools required:
^
11 4 481
Necessary preliminary tasks:
^
Remove cylinder head cover.
^
Remove intermediate lever.
^
Remove inlet camshaft.
Release screw (2) on magnet wheel (1).
Tighten sensor wheel (magnet sensor) to camshaft
5AZ Sensor wheel (magnet sensor) to camshaft
M6x20 ................................................................................................................................................................................................................. 8 Nm
Installation:
Pay attention to journal and groove on intermediate shaft and magnet wheel.
Important:
Magnet wheel (1) is extremely magnetic.
After removing, protect magnet wheel (1) against metal chips by placing it in a plastic bag (2) with a seal.