Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-544002.png)
Fit special tool 11 9 280 on hub for vibration damper with screws (2).
Release central bolt in direction of arrow.
Tighten Torsion damper (hub) to crankshaft (central bolt)
11 21 1AZ Torsion damper (hub) to crankshaft (central bolt)
M14x1.5x74
Joining Torque .................................................................................................................................................................................................. 50 Nm
Torque Angle ........................................................................................................................................................................................................ 180°
Note: Replace screws. Lightly oil screws and threads.
Release bearing pins (1 and 2).
Tighten Screw plug, timing case lower section
6AZ Screw plug, timing case lower section
M16x1.5 ............................................................................................................................................................................................................ 30 Nm
Note: Replace seal.
Remove hub (3) towards front.
Remove chain module with timing chain.
Using a hook (2), pull oil pump chain (1) upwards.
