Cooper (R56) L4-1.6L (N12) (2008)
Fuel Level Sensor: Service and Repair
16 14 017 Removing And Installing/Replacing Fuel Filter With Fuel Level Sensor (50-litre Tank)
Special tools required:
-
16 1 020
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
IMPORTANT:
-
Ensure adequate ventilation in the place of work.
-
Avoid skin contact (wear gloves).
-
Before starting the engine for the first time:
-
Fill fuel tank with at least 5 litres of fuel.
Necessary preliminary tasks:
-
Draw off fuel from fuel tank
-
Remove rear seat
-
Remove complete sensor unit (left)
Installation:
Secure a cable to hose pack through left service opening in tank.
The cable facilitates reinstallation of the hose pack.
Push trim panel (1) forward.
Release screws (2).
Installation:
Tightening torque
2AZ Service cover to body
Type: R55 / R56.....................................................................................................................................................................................................6 Nm
Remove cover (3).