Cooper (R56) L4-1.6L (N12) (2008)
Ignition Coil: Service and Repair
12 13 511 Replacing Ignition Coils (N12)
Necessary preliminary tasks:
-
Read out fault memory of DME control unit.
-
Check stored fault messages
-
Switch off ignition
Release bolts and remove cover (1).
Unlock plug retainer (1) of ignition coil (2) and disconnect plug.
Pull ignition coil (2) up and out.
This procedure is applicable to all ignition coils.
Installation:
Check that rubber seal of ignition coil (1) is correctly seated.