mini Workshop Repair Guides

Mini Workshop Service and Repair Manuals

Keyless Entry Module > < Diagram Information and Instructions|Page 63
Page 6
background image

The power master initialises the network and switches the MOST bus on and off (wake-up, sleep mode).

-

Network master
The network master controls and monitors the MOST bus. Each time the network is started, the exact system configuration is recorded and
compared with a stored target configuration. If systems do not work correctly, these are reset and separated from the MOST bus. Any operating
fault in the network or any deviation from the target configuration is stored in a fault memory for the MOST bus.

CCC user interface

The CCC user interface control unit contains the operating system for controlling the CCC. Signals from the controller for selecting the menus and
submenus are processed in the CCC user interface control unit. To actuate the CID, the red-green-blue signals from the graphics processor are converted
into Low Voltage Differential Signalling (LVDS) digital signals. 

CCC audio system controller

-

Audio master
The audio master collects all the audio signals in the vehicle, processes the audio signals and outputs them over the loudspeakers. The audio
master also produces additional audible signals for warnings and for Park Distance Control (PDC). By mixing or fading in and out, a "softer"
audible change is obtained between the signal sources.

-

Connection master
The connection master distributes the signals of the audio sources and the audible signals to the loudspeakers. The signals are transmitted to the
loudspeakers in the following way:
-

Front left and right (acoustic signals, telephone, messages from the navigation system, traffic information announcements)

-

Front left and right, rear left and right (PDC signals)

-

All loudspeakers (all sources in the "Entertainment" menu)

Notes for service staff

Service staff should note the following points:

-

General information: 

-

Diagnosis: 

-

Encoding/programming: ---

National versions

-

US national version (only E60, E61, E63, E64, E70, E90, E91, E92, E93, R56)
The US version has the two-tuner radio with FM, AM and Weather band (7 channels) radio frequencies.
The R56 only has the frequency bands FM, AM.
The telephone and GPS aerial also contains telephone aerial 2.
The SDARS aerial is installed in conjunction with special equipment (option 655 "BMW satellite tuner").
> E70 and E93 from start of series production 
Of the 8 favourites buttons, 6 can be programmed with certain functions. 2 buttons are assigned fixed functions.

-

Japan national version (not R56)
In the Japanese version, the Car Communication Computer has a MD drive (minidisc) instead of the CD-ROM drive. The two-tuner radio has the
radio frequencies FM, AM and Traffic (2 channels).
In the Japanese version, the Car Communication Computer does not have a yaw-rate sensor or a HIP module.

Subject to change.

Keyless Entry Module > < Diagram Information and Instructions|Page 63