Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1545001.png)
Air Bag Control Module: Service and Repair
65 77 016 Removing And Installing Airbag Control Unit
WARNING:
Comply with airbag safety regulations.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
-
Disconnect battery negative lead
-
Remove center console
Release nut (1) and disconnect ground cable (2).
Unscrew nuts (3).
Tightening torque
1AZ Airbag control unit
R50, R52, R53.................................................................................................................................................................................................. 8.8 Nm
M6 ....................................................................................................................................................................................................................... 8 Nm
Type: R55, R56
Raise centre console bracket (4) in direction of arrow and carefully feed out airbag control unit.
Disconnect plug connections (1) and remove airbag control unit (2).
Installation:
Make sure cables are correctly laid.
