Cooper (R56) L4-1.6L (N12) (2008)
Alignment: Service and Repair
Front
31 33 095 Measuring ride-level height of vehicle
Necessary preliminary tasks:
^
Move vehicle into normal position
Determine actual ride level (A).
Attach tape measure to rim flange at bottom middle and measure to wheel arch trim.
Adjusting Toe-In on Front Axle
32 00 601 Adjusting toe-in on front axle
Note:
If wheel camber is not in the setpoint value range, it is necessary to carry out troubleshooting.
Adjusting toe: Move wheels and steering gear to straight-ahead position.
Release screw (1).
Adjust toe-in to specified value by turning tie rod at hexagon (2).
Installation:
Make sure that boot (3) of tie rod does not turn as well.
Installation:
Tighten tie rod end to tie rod ................................................................................................................................................................................ 27.5 Nm
Chassis/Wheel Alignment Check Procedure
32 00 Chassis/wheel alignment check procedure