Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1053001.png)
Valve Body: Service and Repair
24 30 010 Removing and installing/replacing hydraulic selector unit (AISIN)
Important!
After completion of work, check transmission fluid level.
Make a note of drained ATF quantity.
Required replenishment quantity approx. 4.5 liters.
Important!
Use only the approved automatic transmission fluid in this automatic transmission.
Otherwise the automatic transmission may incur extensive damage!
Do not drain fluid before the transmission has cooled down.
Necessary preliminary tasks:
^
Remove transmission fluid sump
^
Remove transmission oil strainer
Bend open retaining lugs (1) of hand valve lever.
Slacken nut (2).
Tighten AISIN selector slide and oil temperature sensor
M8 nut ............................................................................................................................................................................................................... 10 Nm
Remove hand valve lever (3).
Release plugs (1/2) from holders and disconnect.
Release screw (1).
Tighten AISIN selector slide and oil temperature sensor
M8 nut ............................................................................................................................................................................................................... 10 Nm
Remove oil temperature sensor (2) with locking plate (3).
