Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1095001.png)
Gear Sensor/Switch: Service and Repair
23 14 550 Removing/replacing zero gear sensor
Important!
After installing the zero gear sensor, it is necessary to teach in the position of the zero gear sensor again.
Adjustment is carried out with the "Service function" of the DIS Tester (learn/write zero gear sensor).
Disconnect plug connection (1) on zero gear sensor.
Release screws (1).
Remove zero gear sensor.
Tighten zero gear sensor to transmission ................................................................................................................................................................... 5 Nm
