Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1117001.png)
Control Module: Service and Repair
24 61 500 Removing and installing or replacing EGS control unit
Disconnect battery
Release bolt (1).
Detach retaining bar (2) from control unit.
Tighten holder to firewall
Hexagon nut with clamping piece .................................................................................................................................................................... 4.5 Nm
Disconnect plug (3) and remove control unit from mounting.
Important!
The adaptation values must be reset after the control unit has been replaced.
Note:
Illustration similar.
