Cooper Convertible (R52) L4-1.6L (W10) (2005)
Hood Latch Release Cable: Service and Repair
Removing and Installing/Replacing Cable For Front Engine Hood Locks (With Storage
Compartment)
51 23 211 - Removing and installing/replacing cable for front engine hood locks (with storage compartment)
Necessary preliminary tasks:
-
Remove grille for air inlet/heating on left/right
-
Remove right entrance cover strip See: Interior Moulding / Trim/Scuff Plate/Service and Repair/Removing and Installing/Replacing Front Left or
Right Entrance Cover Strip
-
Disconnect Bowden cable from hood/bonnet lock
W11 engine:
-
Remove intake filter housing
W10 and W17 engines:
-
Remove battery cover
Version with storage compartment:
-
Remove right glovebox
Version with glovebox:
-
Remove right glovebox See: Interior Moulding / Trim/Glove Compartment/Service and Repair/Removing and Installing Right Glovebox
Disconnect Bowden cables (2) from release lever (1).
Installation:
Lay Bowden cables (2) without kinks and correctly through bore (3).