Cooper Convertible (R52) L4-1.6L (W10) (2005)
/l4-1.6l_(w10)/Page-1566005.png)
Press upper tire bead under mounting finger. The tire bead should fit in rollers next to mounting finger.
Important!
Do not pinch or damage bead.
Operate fitting machine forwards in stages (clockwise); while doing so, make sure the lower tire bead remains in the rim well.
After fitting, first release the clamps and then inflate the tire with air (without valve).
Increase pressure up to 3.3 bar (330 kPa) in steps.
Do not increase the tire pressure if the tire beading does not slip into the rim well over its entire circumference. In this case, the tire bead must be pressed
off and the air let out of the tire. Recoat bead seat with mounting paste (refer to BMW Parts Service) and inflate tire to 3.3 bar. When the beading rests
correctly on the bead seats increase the pressure to 4.0 bar so that the tire "fits snugly".
Screw in valve and correct tire pressure.
Important!
Advise the customer to avoid heavy acceleration in the initial period.
The mounting paste can cause the tire to turn on the rim and give rise to imbalance.
