Cooper Convertible (R52) L4-1.6L (W10) (2005)
Position sensor on rim flange.
Turn wheel by hand and measure max. lateral runout See: Specifications/Technical Data.
Carry out measurement on both rim flanges.
Note:
Dial gauge must be vertical to rim flange.
Important!
Avoid transformation errors during subsequent installation tasks See: Service and Repair/Procedures/Stationary Wheel Balancing.
Checking Front and Rear Wheel for Face and Radial Runout
36 10 209 - Checking front and rear wheel for face and radial runout
Special tools required:
-
36 1 030 See: Tools and Equipment/36 1 030 Tester
Necessary preliminary tasks:
-
Check wheel bearings