Cooper Convertible (R57) L4-1.6L (N12) (2009)
Important!
Catch brake fluid in a suitable container.
Release screw (1).
Installation:
Tightening torque 35 11AZ See: Specifications/35 11 Pedal Assembly Console.
Note:
Accessibility only with a 75 mm long extension (2).
Disconnect plug connection (1) on brake light switch.
Detach retaining clip (2) and press out pin in direction of arrow.
Installation:
Check retaining clip (2) and replace if necessary.
Make sure retaining clip (2) is correctly engaged.
Release nuts (3) and remove complete bearing block towards bottom.
Installation:
Replace self-locking nuts.