Cooper Convertible (R57) L4-1.6L (N12) (2009)
/l4-1.6l_(n12)/Page-1077003.png)
Fit dust sleeve (1) in groove (2) of brake calliper housing and press into the annular groove.
Installation:
The area between the dust sleeve and the brake calliper housing must be kept dry. It must not come into contact with Ate brake cylinder paste or brake
fluid so as to ensure that the dust sleeve is perfectly seated.
Lightly press brake piston against dust sleeve (1).
Inflate dust sleeve with compressed air (max. 2 bar) via the connection hole. Dust sleeve snaps over brake piston.
Installation:
Coat dust sleeve and brake piston with brake fluid to facilitate installation of dust sleeve.
Press piston into cylinder bore until dust sleeve (1) snaps into annular groove (2) of brake piston.
Important!
Do not twist brake piston.
