Cooper Convertible (R57) L4-1.6L (N12) (2009)
/l4-1.6l_(n12)/Page-1087002.png)
Release screws (1).
Important!
Control unit must not come into contact with dirt or moisture.
Carefully pull off control unit (2) without tilting.
Installation Note:
Replace screws.
Tighten in diagonal sequence in increments of 1 Nm
Tightening torque 34 51 7AZ See: Specifications/34 51 Slip Control System (ABS, ASC+T, DSC).
Important!
Do not touch plug-in contacts (1) and sealing surface (2) with your fingers.
The seal for the electronic control unit deforms during fitting and thereby achieves its maximum sealing effect. The control unit must therefore not be
removed again after installation or used a second time!
In the event of visible damage, the hydraulic control unit is can no longer be used!
Clean sealing surface (2) of hydraulic control unit with fluff-free cloth (do not use hard or sharp objects).
