Cooper Convertible (R57) L4-1.6L (N12) (2009)
Brake Pad Wear Sensor: Service and Repair
Replacing a Brake Pad Sensor (Rear)
34 35 001 - Replacing a rear brake pad sensor
Necessary preliminary tasks:
-
Remove wheel See: Maintenance/Wheels and Tires/Wheels/Service and Repair/Removal and Replacement/Removing or Installing Front or Rear
Wheel
-
Remove rear right underbody panelling
Important!
The brake pad wear sensor must be replaced once it has been removed (brake pad wear sensor loses its retention capability in the brake
pad).
If a brake pad sensor that has already been ground has to be replaced even though the minimum brake pad thickness See: Brakes and Traction
Control/Specifications/Technical Data/Front Brake has not yet been reached, you must observe the following: The new sliding contact must be filed
down with a file to the same length as the ground sliding contact.
Detach brake pad sensor (1) in direction of arrow from brake pad.
Unclip brake pad sensor (1) from holder (2).
Installation:
Make sure brake pad sensor (1) is correctly seated in brake pad.