Cooper Convertible (R57) L4-1.6L (N12) (2009)
/l4-1.6l_(n12)/Page-737001.png)
Manifold Pressure/Vacuum Sensor: Service and Repair
13 62 010 - Removing and installing/replacing differential pressure sensor (N12)
Necessary preliminary tasks:
-
Remove intake filter housing See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
-
Installation location: On intake air manifold, left side.
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) See: Service Precautions/Vehicle Damage Warnings/Notes
on ESD Protection (Electro Static Discharge)!
Unlock plug (1) and remove.
Release screw.
Pull differential pressure sensor (2) out of intake air manifold.
Installation:
-
Check sealing ring, replace if necessary.
-
Tightening torque 13 62 1AZ See: Fuel Delivery and Air Induction/Specifications/13 62 Senders for Control Unit.
Installation:
Check stored fault messages.
Now clear the fault memory.
