Cooper Convertible (R57) L4-1.6L (N12) (2009)
Wheel Speed Sensor: Service and Repair
Replacing a Rear Pulse Generator
34 52 535 - Replacing a rear pulse generator
Necessary preliminary tasks:
-
Partially detach rear underbody panelling
Release cable from retaining clip on rear axle carrier (1).
Disengage cable from holder (1) at shock absorber.
Release screw (2) and remove pulse generator (3).
Installation:
Tightening torque 34 51 4AZ See: Brakes and Traction Control/Specifications/34 51 Slip Control System (ABS, ASC+T, DSC).
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease (refer to BMW Service Operating Fluids).
Unclip cable from retainers (1).
Disconnect plug connection (2).