Cooper Convertible (R57) L4-1.6L (N12) (2009)
Alignment: Service and Repair
Adjusting Rear Axle
32 00 620 - Adjusting rear axle
Special tools required:
-
32 4 200
Note:
A camber change always means a toe change as well. The camber must therefore be adjusted first.
If wheel camber and toe-in cannot be adjusted within specified range: Troubleshooting on rear axle.
Adjusting camber:
Important!
Observe following sequence:
-
Raise car (wheels free)
-
Slacken screw (1).
-
Adjust camber by turning eccentric disk (2) in direction of max. positive (wheel at bottom is at max. in relation to center of car)
-
Tighten screw (1) slightly
-
Lower vehicle and compress.
-
Slacken screw (1) and adjust camber by turning eccentric disk (2) to setpoint value
-
Tighten down screw (1)
Installation:
Tightening torque 33 32 2AZ See: Suspension/Control Arm/Specifications/Control Arms and Struts (Rear).