Cooper JCW Clubman (R55) L4-1.6L Turbo (N18) (2011)
Body Emblem: Service and Repair
51 14 002 Removing and Installing/Replacing Front Mini Badge
51 14 002 Removing And Installing/Replacing Front MINI Badge
Special tools required:
IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be
observed without fail.
NOTE: The MINI badge is damaged when removed and must be replaced.
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.
*Liner is the protective film on a new plate.