mini Workshop Repair Guides

Mini Workshop Service and Repair Manuals

Removing and Installing Rear Glass Lid|Page 9744 > < Removing and Installing Rear Glass Lid|Page 9742
Page 1
background image

Sunroof / Moonroof Panel: Service and Repair
54 10 240 Removing and Installing/Replacing Front Glass Slide/Tilt Sunroof Cover

54 10 240 Removing And Installing/Replacing Front Glass Slide/Tilt Sunroof Cover

Installation note:

-

Microencapsulated screws (Loctite) must be replaced and may not be reused

-

Screw connection must be completed within 20 mins. (start of curing)

-

Microencapsulated screws must not be retightened

-

Clean thread of nut beforehand in event of repeated use

Release left and right screws (1).
Tightening torque 54 12 04AZ.
Carefully remove the glass slide/tilt sunroof cover upwards.

Installation note:
Replace Torx screw.
Adjust glass slide/tilt sunroof cover.
Carry out initialisation.

Removing and Installing Rear Glass Lid|Page 9744 > < Removing and Installing Rear Glass Lid|Page 9742