Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-913001.png)
Wheel Speed Sensor: Service and Repair
34 52 525 Replacing One Front Pulse Generator
34 52 525 Replacing one front pulse generator
Necessary preliminary tasks:
^
Remove wheel
Remove cable from holder (1) on spring strut.
Release screw (2) and remove pulse generator (3).
Installation:
Tighten pulse generator, front and rear, to steering knuckle / frame side member
4AZ Pulse generator, front and rear, to steering knuckle / frame side member ......................................................................................................... 8 Nm
Disconnect plug connection (1).
Installation:
Make sure plug connection engages correctly.
Installation:
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease (refer to BMW Service Operating Fluids).
