Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-338003.png)
Jointing torque ................................................................................................................................................................................................... 30 Nm
Torque angle ........................................................................................................................................................................................................ 150 °
Note: Replace screws
Set down VANOS adjustment unit on special tool 11 4 480.
Important:
Removed cylinder head:
When using special tool 11 9 000, it will be necessary to remove the aluminum profile insert.
Screw special tool 11 9 661 with special tools 11 9 662 into spark plug holes.
Turn eccentric shaft (1) in direction of ring and lock.
Release all screws on bearing caps (1).
Tighten Inlet camshaft bearing cap to cylinder head
6AZ Inlet Camshaft bearing cap to cylinder head
M6 ..................................................................................................................................................................................................................... 10 Nm
Note: Replace seal
Bearing cap (2) is a thrust bearing and has the number (5).
All bearing caps (1) are identified with numbers from (6 to 9).
