Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-513001.png)
Catalytic Converter: Service and Repair
18 32 005 Removing and installing/replacing catalytic exhaust-gas converter (N14)
Warning!
Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Necessary preliminary tasks:
^
Move front panel into assembly position
Note:
The oxygen sensors are in danger of being damaged when the exhaust manifolds are removed and installed.
Remove control sensor
Remove monitor sensor
Release screw and remove holder (1).
Release screws and remove upper heat shield (1).
Tighten front heat shield to rear heat shield
7AZ Front heat shield to rear heat shield
M6 x 100 ............................................................................................................................................................................................................. 4 Nm
Release screws and remove lower heat shield (1).
Tighten front heat shield to rear heat shield
7AZ Front heat shield to rear heat shield
M6 x 100 ............................................................................................................................................................................................................. 4 Nm
