Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-1095002.png)
Remove switch unit (1) in upward direction.
Installation:
Switch unit (1) can only be installed in one position.
PCB (4) can be inserted turned through 180 degrees.
Position of magnet sensor (3) of PCB (4) must match up with permanent magnet (2) of switch unit (1).
Remove guide (1) in upward direction.
Installation:
Guide (1) can only be installed in one position.
Fit seal (2) on guide (1) and insert in switch housing.
IMPORTANT: Ignition key must be inserted in lock cylinder, otherwise this will be destroyed when removed.
Insert ignition key in lock cylinder (2).
Carefully release catches (1) in outward direction and press out lock cylinder (2) with ignition key.
Installation:
