Cooper S Convertible (R52) L4-1.6L SC (W11) (2005)
/l4-1.6l_sc_(w11)/Page-1202002.png)
Remove torque converter and set down vertically.
When torque converter is removed, transmission oil flows out.
Installation Note:
Do not damage shaft seal and bearing.
If the torque converter is not correctly installed, the driver of the transmission oil pump may be damaged when the transmission is flanged to the
engine.
Align the torque converter in such a way that the opening on the converter hub lines up with the oil pump driver.
Installation Note:
Push torque converter with special tool 24 4 260 through shaft seal onto transmission shaft as far as it will go.
Press torque converter by hand into converter housing. Converter hub opening must snap into place in driver of pump impeller. Torque converter must
be felt to slip inwards.
Determine distance between contact surface and surface (1) of tapped hole in torque converter with special tool 00 2 550 See: Tools and
Equipment/00 2 550 Depth Gauge.
