Cooper S Convertible (R57) L4-1.6L Turbo (N18) (2011)
Length = 6 x window glass diagonal
-
The cutting wire loops must lie on top of each other in area (B).
They must not get caught up in each other. (Otherwise no possibility of cutting the adhesive bead/wire will break.)
Overlapping of cutting wire loops approx. 10 cm.
Distance from right window edge approx. 30 cm.
Pulling cutting wire into vehicle:
-
Cut off wire end (1) at an angle and pierce adhesive bead (2) with it.
-
Wire end must be bent towards window glass.
Laying cutting wire around window glass:
-
Starting from pull-in point, lay wire eyelet created on the outside around the window glass
-
Pull excess wire into passenger compartment
IMPORTANT:
-
Make sure the cutting wire is located at all four corner points below the window glass.
-
Check that the cutting wire is not caught on clamps or body.
-
Secure window glass on outside with adhesive tape against sliding.