200SX V6-2960cc 3.0L SOHC MFI (VG30E) (1987)
Weatherstrip: Customer Interest
Interior - Wind Noise Around A Pillar
Classification:
BF87-007
Reference:
TS87-042
Date:
March 9, 1987
WIND NOISE
APPLIED VEHICLE(S)
1984-1987 200SX
SERVICE INFORMATION
Some 1984-1987 200SX vehicles may exhibit wind noise (buzzing sound) around the "A" pillar. This noise usually occurs when cross-wind conditions
exist. If the door is properly adjusted and the wind noise still exists, add a bead of black RTV silicone adhesive/sealant and butyl to the body side
weatherstrip as described below.
SERVICE PROCEDURE
1.
With the door open, clean the trough of the body side weatherstrip with a solvent (alcohol or equivalent) that leaves no residue.
2.
Apply a continuous bead of black RTV silicone adhesive/sealant (GE, Dow or equivalent) along the indicated portion (A and B) of the
weatherstrip as shown. Wet finger with water and smooth the silicone as required.
NOTE:
Silicone should fill indicated portion (A and B) to be effective.
3.
Remove the lower weatherstrip retaining clip and add a bead of butyl to the indicated portion (C) of the weatherstrip as shown. Replace the
retaining clip.