200SX SE-R L4-1998cc 2.0L DOHC MFI (SR20DE) (1998)
12. Remove aluminum oil pan bolts in numerical order.
13. Remove two engine-to-transaxle bolts and install them into open bolt holes as shown. Tighten both bolts to separate aluminum oil pan from
cylinder block.
14. Remove aluminum oil pan.
a. Insert Tool between cylinder block and aluminum oil pan. Be careful not to damage aluminum mating surface. Do not insert screwdriver, or oil
pan flange will be damaged.
b. Slide Tool by tapping on the side of the Tool with a hammer.
15. Remove the two engine-to-transaxle bolts previously installed in aluminum oil pan.
INSTALLATION