nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

ABOUT US
Vacuum Cut Valve Bypass Valve <--> [Leak Detection Solenoid, Evaporative System] > < Diagram Information and Instructions|Page 5294

200SX SE-R L4-1998cc 2.0L DOHC MFI (SR20DE) (1998)

Page 1
background image

Leak Detection Sensor: Testing and Inspection

COMPONENT INSPECTION 
EVAP Control System Pressure Sensor 

1. Remove EVAP control system pressure sensor with its harness connector connected.
2. Remove hose from EVAP control system pressure sensor.
3. Use pump to apply vacuum and pressure to EVAP control system pressure sensor as shown in figure.
4. Check output voltage between ECM terminal (67) and engine ground.

CAUTION:
-

Always calibrate the vacuum pump gauge when using it.

-

Do not apply below -20 kPa (-150 mmHg, -5.91 inHg) or over 20 kPa (150 mmHg, 5.91 inHg) of pressure.

5. If NG, replace EVAP control system pressure sensor.

Vacuum Cut Valve Bypass Valve <--> [Leak Detection Solenoid, Evaporative System] > < Diagram Information and Instructions|Page 5294