200SX SE L4-1597cc 1.6L DOHC MFI (GA16DE) (1997)
8. Remove D-ring and oil seal from piston.
INSPECTION
Reverse Clutch Snap Ring, Spring Retainer And Return Springs
-
Check for deformation, fatigue or damage.
Replace if necessary.
-
When replacing spring retainer and return springs, replace them as a set.
High Clutch Drive Plates
-
Check facing for burns, cracks or damage.
-
Measure thickness of facing. If not within wear limit, replace.
Thickness of drive plate:
Standard value: 2.0 mm (0.079 inch)
Wear limit: 1.8 mm (0.071 inch)
High Clutch Piston
-
Make sure check balls are not fixed.
-
Apply compressed air to check ball oil hole opposite the return spring.
-
Make sure there is no air leakage.
-
Apply compressed air to oil hole on return spring side to make sure air leaks past ball.