200SX SE L4-1597cc 1.6L DOHC MFI (GA16DE) (1997)
Joint Assembly (Wheel Side)
^
Replace joint assembly if it is deformed or damaged.
Support Bearing
^
Make sure support bearing rolls freely and is free from noise, cracks, pitting and wear.
Support Bearing Bracket
^
Check support bearing bracket for cracks with a magnetic exploration or dyeing test.
ASSEMBLY
Support Bearing
1. Install bearing into retainer.
2. Install dust shield.
3. Install snap ring.
4. Press drive shaft into bearing.
5. Install snap ring.
6. Install new dust shield.
Wheel Side
1. Install boot and new small boot band on drive shaft.