200SX SE L4-1597cc 1.6L DOHC MFI (GA16DE) (1997)
Input Shaft: Service and Repair
INPUT SHAFT AND GEARS
DISASSEMBLY
1. Before disassembly, check 5th input gear end play. Gear end play: 0.18 - 0.31 mm (0.0071 - 0.0122 inch)
If not within specification, disassemble and check contact surface of gear, shaft and hub. Then check clearance of snap ring groove. Refer to
Assembly.
2. Remove snap ring and 5th stopper.
3. Remove 5th synchronizer, 5th input gear and 5th gear needle bearing with Tool.
4. Remove snap ring of input shaft front bearing and spacer.
5. Pull out input shaft front bearing.
6. Remove bearing retainer.
INSPECTION
Gear And Shaft
-
Check shaft for cracks, wear or bending.
-
Check gears for excessive wear, chips or cracks.