240SX L4-2.4L (KA24DE) (1993)
Clearance Between Baulk Ring And Gear - (1st, 3rd, Main Drive And O.D. Baulk Ring):
-
Measure clearance between baulk ring and gear.
If the clearance is smaller than the wear limit, replace baulk ring.
-
Measure wear of 2nd baulk ring.
a. Place baulk rings in position on synchronizer cone.
b. While holding baulk rings against synchronizer cone as far as it will go measure dimensions "A" and "B".
c. If dimension "A" or "B" is smaller than the wear limit, replace baulk ring.
BEARINGS