Nissan and Datsun Workshop Service and Repair Manuals

Throttle Position Sensor: Testing and Inspection

COMPONENT INSPECTION 

1. Start engine and warm it up sufficiently.
2. Turn ignition switch "OFF".

3. Disconnect throttle position sensor harness connector.
4. Check resistance between terminals 02 and 03 while opening throttle valve manually.

Throttle Valve Conditions / Resistance at 25°C(77°F)
Completely closed / Approximately 0.5 K Ohms 
Partially open / 0.5 - 4.0 K Ohms
Completely open / Approximately 4.0 K Ohms 

If NG, replace throttle position sensor.
To adjust throttle position sensor, perform "BASIC INSPECTION".