300ZX V6-2960cc SOHC Turbo (VG30ET) (1984)
Fuel Injector Wiring Harness: All Technical Service Bulletins
Recall - Fuel Injectors & Hoses, EGI Harness Bracket
Reference: NTB96-010j
Date: October 2, 1996
VOLUNTARY SERVICE CAMPAIGN - FUEL INJECTORS AND HOSES
300ZX TURBO EGI HARNESS BRACKET AT THE AAC VALVE
This bulletin is a supplement to NTB96-010a and contains revised Service and Parts Information.
Refer to NTB96-010a for complete campaign details.
APPLIED VEHICLE: 1984-89 300ZX Turbo (Z31)
APPLIED VIN: All
SERVICE INFORMATION
The EGI harness must be secured at all the original locations around the intake plenum with the OEM harness clamps. The 300ZX turbo requires a right
angle bracket to mount to a harness clip at the AAC valve (refer to Figure 1). This bracket/clip may be missing if the AAC valve was previously
replaced. If the EGI harness bracket/clip at the AAC valve is missing, install the missing bracket/clamp using the part numbers listed at the end of this
bulletin.
PARTS INFORMATION
DESCRIPTION
PART # /PFP
EGI harness bracket (at AAC valve)
24210-01P03
EGI harness clip
24225-01P02