300ZX V6-2960cc SOHC Turbo (VG30ET) (1984)
52.
Install the tie wraps on the coolant lines.
NOTE:
Install the tie wraps carefully, being sure not to crimp or kink the lines (Figure 16).
53.
Install the lower engine cover.
54.
NOTE: Prior to starting the engine, turn the ignition key to the ON position and make sure that the oil pressure light comes ON. After
starting the engine, the oil pressure light should go OFF within two or three seconds. If it doesn't go OFF, turn the engine OFF immediately
and check the engine oil dipstick level and for possible oil leaks.
55.
Start and run the engine. Check for possible oil or water leaks.
CAUTION:
After starting the engine, do not operate the engine above normal idle speed for at least 2 to 3 minutes.
PIPING KIT COMPONENTS (P/N 14411-01P25)
DESCRIPTION
PART NUMBER
QUANTITY
HOSE - WATER
14056-01P02
1
HOSE - WATER
14056-01P13
1
TUBE ASSEMBLY - WATER INLET
14499-01P02
1
TUBE ASSEMBLY - OIL
15192-01P00
1
BRACKET - AIR INLET PIPE
14467-01P00
1
TIE WRAPS
01552-00411
2
GASKET - EYE BOLT
15189-01P00
4
BOLT - EYE
15188-01P00
2
BOLT - HEX
08120-61233
1
CLAW
24220-05E00
4
HEAT SHIELD - LOWER
74767-02P00
4*
*Only one (1) heat shield is required for this procedure. Discard the remaining heat shields.
Warranty Information
Refer to Section DE in the Warranty Flat Rate Manual.
SERVICE MANUAL CHANGE
Please add the following note to page EF&EC-65 of the 1984 300ZX Service Manual:
"Refer to Technical Bulletin EF86-002 (TS86-031) for turbocharger replacement."