300ZX Coupe V6-2960cc DOHC (VG30DE) (1994) Closed Throttle Position Switch Diagrams
Closed Throttle Position Switch: Service and Repair
REMOVAL
-
Turn the ignition key off.
-
Disconnect the idle switch and throttle sensor connectors.
-
Remove the 2 bolts securing the unit to the throttle chamber and remove the unit.
INSTALLATION
-
Install the unit to the throttle shaft, aligning the flat area on the shaft with the flat area on the unit.
-
Install the screws and tighten slightly. [1]
-
Reconnect the throttle sensor and idle switch connectors.
NOTE: [1] Tighten mounting screws completely, after adjustments are made.
ADJUSTMENT
NOTE: Since the Throttle Position Sensor (TPS) and the Closed Throttle Position (CTP) Switch are housed inside one component body; The Closed
Throttle Position Switch contacts will be adjusted correctly when the integral Throttle Position Sensor is adjusted.
Refer to Adjustment for Throttle Position Sensor.